Zoom F8n - Page 110

Output settings
Setting signals sent to headphones (Headphone Routing)
110
Using mono headphone output
6. Use to select MONO Mix ,
and press
.
7. Press .
Setting signals sent to headphones (Headphone Routing) (continued)
Monitoring mid-side stereo signals
Signals from a mid-side stereo mic can be converted to an
ordinary stereo signal for monitoring.
6. Use to select MS ,
and press
.
7. Press .
NOTE
• This is disabled for stereo-linked tracks that have Stereo Link
Mode set to MS Stereo Link.
• This is only enabled for tracks that have a mid-side microphone
or mid-side mic capsule connected and the Side Mic Level set to
RAW.
• When mid-side stereo monitoring is enabled, the prefader tracks
will be routed automatically to the headphone channels, with the
odd-numbered to the left and the even-numbered to the right. In
this case, the routing cannot be changed manually.