ZyXEL Communications AMG1302-T11C - Page 26

Chapter 3 Quick Start Wizard
AMG1302-T11C User’s Guide
26
Figure 9 Internet Access Wizard Setup: IPoA Configuration
The following table describes the fields in this screen.
Note: Virtual Path Identifier (VPI) and Virtual Channel Identifier (VCI) define a virtual
circuit.
Table 3 Internet Access Wizard Setup: IPoA Configuration
LABEL DESCRIPTION
Encapsulation Select the encapsulation type your ISP uses from the Encapsulation drop-down list box:
IPoA, ENET ENCAP, PPPoA, or PPPoE.
Multiplex Select the multiplexing method used by your ISP from the Multiplex drop-down list box
either VC-based or LLC-based.
VPI Enter the Virtual Path Identifier (VPI) assigned to you. This field may already be
configured.
VCI Enter the Virtual Channel Identifier (VCI) assigned to you. This field may already be
configured.
IP Address Enter the IP address of the AMG1302-T11C.
Default Gateway Enter the default gateway of the ZyXEL Device.
Primary DNS
Server
Enter the primary DNS server IP address for the AMG1302-T11C.
Secondary DNS
Server
Enter the secondary DNS server IP address for the AMG1302-T11C.
Back Click this to return to the previous screen without saving.
Next Click this to continue to the next wizard screen. The next wizard screen you see depends
on what protocol you chose above.
Close Click this to close the wizard screen without saving.