Chapter 3 Quick Start Wizard
AMG1302-T11C User’s Guide
27
Figure 10 Internet Connection with ENET ENCAP
The following table describes the fields in this screen.
Table 4 Internet Connection with ENET ENCAP
LABEL DESCRIPTION
Encapsulation Select the encapsulation type your ISP uses from the Encapsulation drop-down list box:
IPoA, ENET ENCAP, PPPoA, or PPPoE.
Multiplex Select the multiplexing method used by your ISP from the Multiplex drop-down list box
either VC-based or LLC-based.
VPI Enter the Virtual Path Identifier (VPI) assigned to you. This field may already be
configured.
VCI Enter the Virtual Channel Identifier (VCI) assigned to you. This field may already be
configured.
Select Yes to enter specific IP information from your Internet service provider.
Enter your Internet
access information exactly as your service provider gave it to you.
IP Address Enter the IP address of the AMG1302-T11C.
Subnet Mask Enter the subnet mask in dotted decimal notation.
Refer to the appendix to calculate a subnet mask if you are implementing subnetting.
Default Gateway You must specify a gateway IP address (supplied by your ISP) when you use ENET ENCAP
in the Encapsulation field in the previous screen.
Primary DNS
Server
Enter the primary DNS server IP address for the AMG1302-T11C.
Secondary DNS
Server
Enter the secondary DNS server IP address for the AMG1302-T11C.
Back Click this to return to the previous screen without saving.
Next Click this to continue to the next wizard screen. The next wizard screen you see depends
on what protocol you chose above.
Close Click this to close the wizard screen without saving.
To Next Page
Loading...
