Chapter 10 NAT
LTE3302-M432 & LTE3312-M432 User’s Guide
100
Note: Only one LAN computer can use a trigger port (range) at a time.
Figure 66 Configuration > Network > NAT > Port Trigger
The following table describes the labels in this screen.
Table 42 Configuration > Network > NAT > Port Trigger
LABEL DESCRIPTION
Application Rule Summary
Port Trigger Rules
# This is the rule index number (read-only).
Name Type a unique name (up to 15 characters) for identification purposes. All characters are
permitted - including spaces.
WAN Interface Select the WAN interface through which the matched packets are transmitted.
Incoming Port Incoming Port is a port (or a range of ports) that a server on the WAN uses when it sends out a
particular service. The LTE Device forwards the traffic with this port (or range of ports) to the
client computer on the LAN that requested the service.
Start Port Type a port number or the starting port number in a range of port numbers.
End Port Type a port number or the ending port number in a range of port numbers.
Trigger Port The trigger port is a port that causes (or triggers) the LTE Device to record the IP address of the
LAN computer that sent the traffic to a server on the WAN.
Cancel Click Cancel to begin configuring this screen afresh.
Apply Click Apply to save your changes back to the LTE Device.
To Next Page
Loading...
