Chapter 1 Introduction
LTE3302-M432 & LTE3312-M432 User’s Guide
19
1.3.4 Wall Mounting
You may need screw anchors if mounting on a concrete or brick wall.
1 Select a position free of obstructions on a wall strong enough to hold the weight of the device.
2 Mark two holes on the wall at the appropriate distance apart for the screws.
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full
depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave
a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all
the way in - leave a gap of about 0.5 cm.
4 Make sure the screws are fastened well enough to hold the weight of the LTE Device with the
connection cables.
5 Align the holes on the back of the LTE Device with the screws on the wall. Hang the LTE Device on the
screws.
Figure 9 Wall Mounting Example
Note: The mounting kit is not provided.
Table 3 Wall Mounting Information
Distance between holes 55 mm
M4 Screws Two
Screw anchors (not provided) Two
To Next Page
Loading...
