Chapter 9 DHCP Server
LTE3302-M432 & LTE3312-M432 User’s Guide
94
9.4 DHCP Client List Screen
The DHCP table shows current DHCP client information (including IP Address, Host Name and MAC
Address) of network clients using the LTE Device’s DHCP servers.
Configure this screen to always assign an IP address to a MAC address (and host name). Click
Configuration > Network > DHCP Server > Client List.
Note: You can also view a read-only client list by clicking Monitor > DHCP Server.
Figure 61 Configuration > Network > DHCP Server > Client List
The following table describes the labels in this screen.
Cancel Click Cancel to begin configuring this screen afresh.
Apply Click Apply to save your changes back to the LTE Device.
Table 37 Configuration > Network > DHCP Server > Advanced (continued)
LABEL DESCRIPTION
Table 38 Configuration > Network > DHCP Server > Client List
LABEL DESCRIPTION
DHCP Client Table
# This is the index number of the host computer.
Status This field displays whether the connection to the host computer is up (a yellow bulb) or down (a
gray bulb).
Host Name This field displays the computer host name.
IP Address This field displays the IP address relative to the # field listed above.
MAC Address This field shows the MAC address of the computer with the name in the Host Name field.
Every Ethernet device has a unique MAC (Media Access Control) address which uniquely
identifies a device. The MAC address is assigned at the factory and consists of six pairs of
hexadecimal characters, for example, 00:A0:C5:00:00:02.
Reserve Select this if you want to reserve the IP address for this specific MAC address.
Cancel Click Cancel to reload the previous configuration for this screen.
Apply Click Apply to save your changes back to the LTE Device.
To Next Page
Loading...
