Chapter 7 Wireless LAN
LTE3302-M432 & LTE3312-M432 User’s Guide
76
7.3.3 WPA-PSK/WPA2-PSK
Select WPA-PSK or WPA2-PSK from the Security Mode list.
Figure 45 Configuration > Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the LTE Device and the wireless stations must use
the same WEP key for data transmission.
If you chose 64-bits, then enter any 5 ASCII characters or 10 hexadecimal characters ("0-9",
"A-F").
If you chose 128-bits, then enter 13 ASCII characters or 26 hexadecimal characters ("0-9", "A-
F").
You must configure at least one key, only one key can be activated at any one time. The
default key is key 1.
Cancel Click Cancel to reload the previous configuration for this screen.
Apply Click Apply to save your changes back to the LTE Device.
Table 23 Configuration > Network > Wireless LAN > General: Static WEP (continued)
LABEL DESCRIPTION
To Next Page
Loading...
