ZyXEL Communications LTE3302-M432 - Multiple APs, MAC Filter, QoS

Chapter 7 Wireless LAN
LTE3302-M432 & LTE3312-M432 User’s Guide
78
The following table describes the labels in this screen.
7.4 More AP Screen
This screen allows you to enable and configure multiple wireless networks and guest wireless network
settings on the LTE Device.
You can configure up to four SSIDs to enable multiple BSSs (Basic Service Sets) on the LTE Device. This
allows you to use one access point to provide several BSSs simultaneously. You can then assign varying
security types to different SSIDs. Wireless clients can use different SSIDs to associate with the same access
point.
Click Configuration > Network > Wireless LAN > More AP. The following screen displays.
Figure 47 Configuration > Network > Wireless LAN > More AP
Table 25 Configuration > Network > Wireless LAN > General: WPA/WPA2
LABEL DESCRIPTION
Security Mode Select WPA or WPA2 to enable data encryption.
WPA Compatible This check box is available only when you select WPA2-PSK or WPA2 in the Security Mode
field.
Select the check box to have both WPA2 and WPA wireless clients be able to
communicate with the LTE Device even when the LTE Device is using WPA2-PSK or WPA2.
Group Key Update
Timer
The Group Key Update Timer is the rate at which the AP (if using WPA-PSK/WPA2-PSK key
management) or RADIUS server (if using WPA/WPA2 key management) sends a new group
key out to all clients. The re-keying process is the WPA/WPA2 equivalent of automatically
changing the WEP key for an AP and all stations in a WLAN on a periodic basis. Setting of
the Group Key Update Timer is also supported in WPA-PSK/WPA2-PSK mode.
Authentication Server
IP Address Enter the IP address of the external authentication server in dotted decimal notation.
Port Number Enter the port number of the external authentication server.
You need not change this value unless your network administrator instructs you to do so
with additional information.
Shared Secret Enter a password (up to 127 alphanumeric characters) as the key to be shared between
the external authentication server and the LTE Device.
The key must be the same on the external authentication server and your LTE Device. The
key is not sent over the network.
Cancel Click Cancel to reload the previous configuration for this screen.
Apply Click Apply to save your changes back to the LTE Device.