Chapter 7 Wireless LAN
LTE3302-M432 & LTE3312-M432 User’s Guide
74
Note: If you do not enable any wireless security on your LTE Device, your network is accessible
to any wireless networking device that is within range.
Figure 43 Configuration > Network > Wireless LAN > General: No Security
The following table describes the labels in this screen.
7.3.2 WEP Encryption
WEP encryption scrambles the data transmitted between the wireless stations and the access points to
keep network communications private. It encrypts unicast and multicast communications in a network.
Both the wireless stations and the access points must use the same WEP key.
Your LTE Device allows you to configure up to four 64-bit or 128-bit WEP keys but only one key can be
enabled at any one time.
Select Static WEP from the Security Mode list.
Table 22 Configuration > Network > Wireless LAN > General: No Security
LABEL DESCRIPTION
Security Mode Choose No Security from the drop-down list box.
Cancel Click Cancel to reload the previous configuration for this screen.
Apply Click Apply to save your changes back to the LTE Device.
To Next Page
Loading...
