Chapter 13 Interface Group
LTE3302-M432 & LTE3312-M432 User’s Guide
110
13.2.1 Interface Group > Add Screen
Click the Add button in the Interface Group screen to open the following screen. Use this screen to
create a new interface group.
Note: An interface can belong to only one group at a time.
Figure 76 Configuration > Network > Interface Group > Add
The following table describes the fields in this screen.
Table 49 Configuration > Network > Interface Group > Add
LABEL DESCRIPTION
Group Name Enter a name to identify this group. You can enter up to 30 characters. You can use letters,
numbers, hyphens (-) and underscores (_). Spaces are not allowed.
Enable Tx TAG Click the check box to set the port to tag or not to tag all outgoing traffic with the VLAN ID.
VID This shows the VLAN ID number (from 0 to 4094) for traffic through the interfaces in this group.
This field is not configurable and the VLAN ID is assigned automatically by the system.
Grouped LAN
Interfaces
This shows the LAN port(s) or WLAN interface(s) as a member of the VLAN interface group.
Select any interfaces that you don’t want and click the right arrow button to remove them from
this group.
Available LAN
Interfaces
This shows the available LAN interface(s) (Ethernet LAN or Wireless LAN) that can be selected to
form a VLAN interface group.
Select the interfaces that you want and click the left arrow button to add them to this group.
Back Click Back to quit and return to the previous screen.
Cancel Click Cancel to exit this screen without saving.
Apply Click Apply to save your changes back to the LTE Device.
To Next Page
Loading...
