Chapter 7 Wireless LAN
LTE3302-M432 & LTE3312-M432 User’s Guide
83
7.7 Quality of Service (QoS) Screen
The QoS screen allows you to automatically give a service (such as VoIP and video) a priority level.
Click Configuration > Network > Wireless LAN > QoS. The following screen appears.
Figure 51 Configuration > Network > Wireless LAN > QoS
The following table describes the labels in this screen.
7.8 WPS Screen
Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click Configuration > Network > Wireless LAN > WPS.
Note: With WPS, wireless clients can only connect to the wireless network using the first SSID on
the LTE Device.
Cancel Click Cancel to reload the previous configuration for this screen.
Apply Click Apply to save your changes back to the LTE Device.
Table 29 Configuration > Network > Wireless LAN > Advanced (continued)
LABEL DESCRIPTION
Table 30 Configuration > Network > Wireless LAN > QoS
LABEL DESCRIPTION
WMM QoS Select Enable to have the LTE Device automatically give a service a priority level
according to the ToS value in the IP header of packets it sends. WMM QoS (Wifi
MultiMedia Quality of Service) gives high priority to voice and video, which makes them
run more smoothly.
This field is not configurable and the LTE Device automatically enables WMM QoS if you
select 802.11n, 802.11gn or 802.11bgn in the Wireless LAN > General screen.
Cancel Click Cancel to reload the previous configuration for this screen.
Apply Click Apply to save your changes to the LTE Device.
To Next Page
Loading...
