Chapter 20 Bandwidth Management
LTE3302-M432 & LTE3312-M432 User’s Guide
133
20.5 Advanced Screen
Use this screen to configure bandwidth management rules for the pre-defined services or applications.
You can also use this screen to configure bandwidth management rule for other services or applications
that are not on the pre-defined list of LTE Device. Additionally, you can define the IP addresses and port
for a service or application.
Click Configuration > Management > Bandwidth MGMT > Advanced to open the bandwidth
management Advanced screen.
Figure 91 Management > Bandwidth Management > Advanced
The following table describes the labels in this screen.
Flexible Bandwidth
Management
Select Enable to use up to 100% of the configured bandwidth. If you select Disable, you can
only use up to 33% of the configured bandwidth.
Cancel Click Cancel to begin configuring this screen afresh.
Apply Click Apply to save your customized settings.
Table 61 Configuration > Management > Bandwidth MGMT > General (continued)
LABEL DESCRIPTION
Table 62 Management > Bandwidth Management > Advanced
LABEL DESCRIPTION
Add New Rule Click this to open a screen where you can create a new bandwidth management rule for a
service or application.
Rule List
# This is the number of an individual bandwidth management rule.
Status This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
Grouping This field displays the IP address or a range of IP addresses of the destination computer for
whom this rule applies.
Service This field displays the protocol and port used for the service.
Control This field displays whether the maximum/minimum bandwidth allowed or a priority level is
specified in the rule.
Direction These read-only labels represent the physical interfaces. Bandwidth management applies to
all traffic flowing out of the router through the interface, regardless of the traffic’s source.
To Next Page
Loading...
