LTE3302-M432 & LTE3312-M432 User’s Guide
127
CHAPTER 19
Remote Management
19.1 Overview
This chapter provides information on the Remote Management screens. Remote Management allows
you to manage your LTE Device from a remote location
Remote Management allows you to manage your EMG2926-Q10A from a remote location through the
following interfaces:
• LAN and WAN
• LAN only
•WAN only
Note: The LTE Device is managed using the Web Configurator.
19.2 What You Can Do
• Use the WWW screen to define the interface/s from which the LTE Device can be managed remotely
using the web and specify a secure client that can manage the LTE Device (Section 19.4 on page
128).
• Use the Remote Management screen to control through which IP addresses can access the LTE
Device (Section 19.5 on page 129).
19.3 What You Need to Know
Remote management over LAN or WAN will not work when:
1 The IP address in the Secured Client IP Address field (Section 19.4 on page 128) does not match the
client IP address. If it does not match, the LTE Device will disconnect the session immediately.
2 There is already another remote management session. You may only have one remote management
session running at one time.
3 There is a firewall rule that blocks it.
19.3.1 System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds). The LTE
Device automatically logs you out if the management session remains idle for longer than this timeout
To Next Page
Loading...
