ZyXEL Communications LTE3302-M432 - WWW Screen

Chapter 19 Remote Management
LTE3302-M432 & LTE3312-M432 User’s Guide
128
period. The management session does not time out when a statistics screen is polling. You can change
the timeout period in the Maintenance > General screen
19.4 WWW Screen
To change your LTE Device’s remote management settings, click Configuration > Management >
Remote MGMT to open the WWW screen.
Note: You must enable the remote management service in the Configuration > Management
> Remote MGMT > Remote Management screen for the settings in the WWW screen to
take effect.
Figure 87 Configuration > Management > Remote MGMT > WWW
The following table describes the labels in this screen.
Table 59 Configuration > Management > Remote MGMT > WWW
LABEL DESCRIPTION
HTTPS
Port You may change the server port number for a HTTPS service if needed. However you must
use the same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the LTE Device using this
HTTPS service.
Secured Client IP
Address
Select All to allow all computers to access the LTE Device using the HTTPS service.
Otherwise, check Selected and specify the IP address of the computer that can access the
LTE Device.
HTTP
Port You may change the server port number for a HTTP service if needed. However you must
use the same port number in order to use that service for remote management.