Chapter 6 WAN
LTE3302-M432 & LTE3312-M432 User’s Guide
65
Figure 38 Configuration > Network > WAN > Network Scan
The following table describes the labels in this screen.
Table 17 Configuration > Network > WAN > Network Scan
LABEL DESCRIPTION
Physical Interface This shows the type of the interface used by the WAN connection.
Network Type Select the type of the network (4G only, 3G only, or 3G/4G) to which you want the LTE
Device to connect when there is a SIM card inserted.
Scan Approach Select Auto to have the LTE Device connect to an available network using the default
settings on the SIM card. If the currently registered mobile network is not available or the
mobile network’s signal strength is too low, the LTE Device switches to another available
mobile network.
Select Manually to search for and select the mobile network(s) to which you want the LTE
Device to connect.
Network Provider List This table is available only when you set Scan Approach to Manually.
Click Scan to search for available mobile networks based on the network type you
selected.
Click Apply to save your changes in the Action field.
Provider Name This shows the name of the service provider.
Mobile System This shows the mobile telecommunications standard supported by the mobile network.
Network Status This shows whether the mobile network is available.
Action Click Select to have the LTE Device establish a connection to the selected mobile
network.
Cancel Click Cancel to reload the previous configuration for this screen.
Refresh Click Refresh to update this screen.
Apply Click Apply to save your changes back to the LTE Device.
To Next Page
Loading...
