Chapter 7 Wireless LAN
LTE3302-M432 & LTE3312-M432 User’s Guide
87
Figure 55 Configuration > Network > Wireless LAN > WDS
The following table describes the labels in this screen.
Table 34 Configuration > Network > Wireless LAN > WDS
LABEL DESCRIPTION
WDS Setup
Basic Setting Select Disable to turn off the WDS function on the LTE Device.
Select AP+Bridge to have the LTE Device function as a bridge and access point
simultaneously.
Select Bridge Only to have the LTE Device act as a wireless bridge only.
Local MAC Address This shows the MAC address of the LTE Device.
Remote MAC
Address
Type the MAC address of the peer device in a valid MAC address format, that is, six
hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Cancel Click Cancel to reload the previous configuration for this screen.
Apply Click Apply to save your changes back to the LTE Device.
To Next Page
Loading...
