Chapter 10 NAT
LTE3302-M432 & LTE3312-M432 User’s Guide
97
Note: Many residential broadband ISP accounts do not allow you to run any server processes
(such as a Web or FTP server) from your location. Your ISP may periodically check for
servers and may suspend your account if it discovers any active services at your
location. If you are unsure, refer to your ISP.
Port forwarding allows you to define the local servers to which the incoming services will be forwarded.
To change your LTE Device’s port forwarding settings, click Configuration > Network > NAT > Port
Forwarding. The screen appears as shown.
Note: If you do not assign a Default Server, the LTE Device discards all packets received for
ports that are not specified in this screen or remote management.
Refer to Appendix B on page 183 for port numbers commonly used for particular services.
Figure 64 Configuration > Network > NAT > Port Forwarding
The following table describes the labels in this screen.
Table 40 Configuration > Network > NAT > Port Forwarding
LABEL DESCRIPTION
Default Server Setup
Default Server In addition to the servers for specified services, NAT supports a default server. A default
server receives packets from ports that are not specified in the Port Forwarding screen. You
can decide whether you want to use the default server or specify a server manually.
Select this to use the default server.
Change to Server Select this and manually enter the server’s IP address.
To Next Page
Loading...
