LTE3311 Series User’s Guide
102
CHAPTER 12
Routing
12.1 Overview
This chapter shows you how to configure static routes for your LTE3311.
The LTE3311 usually uses the default gateway to route outbound traffic from computers on the LAN
to the Internet. To have the LTE3311 send data to devices not reachable through the default
gateway, use static routes.
For example, the next figure shows a computer (A) connected to the LTE3311’s LAN interface. The
LTE3311 routes most traffic from A to the Internet through the LTE3311’s default gateway (R1).
You create one static route to connect to services offered by your ISP behind router R2. You create
another static route to communicate with a separate network behind a router R3 connected to the
LAN.
Figure 64 Example of Static Routing Topology
12.2 Static Route Screen
Click Network > Routing > Static Route to open the Static Route screen.
To Next Page
Loading...
