Chapter 4 Tutorials
LTE3311 Series User’s Guide
41
For example, you may set up three wireless networks (A, B and C) in your office. A is for workers,
B is for guests and C is specific to a VoIP device in the meeting room.
4.4.1 Configuring Security Settings of Multiple SSIDs
The LTE3311 is in router mode by default.
This example shows you how to configure the SSIDs with the following parameters on your
LTE3311 .
1 Connect your computer to the LAN port of the LTE3311 using an Ethernet cable.
2 The default IP address of the LTE3311is “192.168.1.1”. In this case, your computer must have an IP
address in the range between “192.168.1.2” and “192.168.1.254”.
3 Click Start > Run on your computer in Windows. Type “cmd” in the dialog box. Enter “ipconfig” to
show your computer’s IP address. If your computer’s IP address is not in the correct range then see
Appendix C on page 190 for information on changing your computer’s IP address.
4 After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and
type “http://192.168.1.1” as the web address in your web browser.
5 Enter “admin” as the user name and “1234” (default) as the password and click Login.
6 Type a new password and retype it to confirm, then click Apply. Otherwise, click Ignore.
A
B
C
SSID_Guest
SSID_Worker
SSID_VoIP
SSID SECURITY TYPE KEY
SSID_Worker WPA2-PSK
WPA Compatible
DoNotStealMyWirelessNetwork
SSID_VoIP WPA-PSK VoIPOnly12345678
SSID_Guest WPA-PSK keyexample123
To Next Page
Loading...
