ZyXEL Communications LTE3311 series - How to Use the RESET Button; The WPS Button; SIM Card Slot

Chapter 1 Introduction
LTE3311 Series User’s Guide
15
1.5.1 How to Use the RESET Button
1 Make sure the power LED is on.
2 Press the RESET button for one to four seconds to restart/reboot the LTE3311.
3 Press the RESET button for longer than ten seconds to set the LTE3311 back to its factory-default
configurations.
1.6 The WPS Button
Your LTE3311 supports Wi-Fi Protected Setup (WPS), which is an easy way to set up a secure
wireless network. WPS is an industry standard specification, defined by the Wi-Fi Alliance.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Each WPS connection works between two devices. Both
devices must support WPS (check each device’s documentation to make sure).
Depending on the devices you have, you can either press a button (on the device itself, or in its
configuration utility) or enter a PIN (a unique Personal Identification Number that allows one device
to authenticate the other) in each of the two devices. When WPS is activated on a device, it has two
minutes to find another device that also has WPS activated. Then, the two devices connect and set
up a secure network by themselves.
You can use the WPS button ( ) on the top panel of the LTE3311 to activate WPS in order to
quickly set up a wireless network with strong security.
1 Make sure the power LED is on (not blinking).
2 Press the WPS button for more than three seconds and release it. Press the WPS button on another
WPS-enabled device within range of the LTE3311.
Note: You must activate WPS in the LTE3311 and in another wireless device within two
minutes of each other.
For more information on using WPS, see Section 4.2 on page 34.
1.7 SIM Card Slot
The LTE3311 comes with a built-in 3G/4G module for 3G/4G connections. To set up a 3G/4G
connection using the built-in 3G/4G module, just insert a 3G/4G SIM card into the SIM card slot at
the back of the LTE3311.
Note: You must insert the 4G SIM card into the card slot before turning on the LTE3311.