Chapter 18 Voice over 3G
LTE3311 Series User’s Guide
138
18.4 Telephone Conf. Screen
Use this screen to configure call features. To access this screen, click Application > Voice over
3G > Telephone Conf..
Figure 90 Application > Voice over 3G > Telephone Conf.
The following table describes the labels in this screen.
Phone This field displays the mobile identification number of the contact.
Click Edit and enter the 10-digit mobile subscription identification number (MSIN) used
to identify the contact.
Enable Select this option to activate this entry.
Actions Click the Edit icon to create a new contact or change the contact name or phone
number.
Apply
Click this to save your changes and to apply them to the LTE3311.
Cancel Click this to set every field in this screen to its last-saved value.
Table 64 Application > Voice over 3G > Phone Book
LABEL DESCRIPTION
Table 65 Application > Voice over 3G > Telephone Conf.
LABEL DESCRIPTION
Caller ID This shows the caller ID standard (ETSI DTMF) used to send identification when you
make Vo3G phone calls.
Dialling Timeout Enter the number of seconds the LTE3311 should wait after you stop dialing numbers
before it makes the phone call. The value depends on how quickly you dial phone
numbers.
If you select Enable in the Use # to End Dialling field, you can press the pound key
(#) to tell the LTE3311 to make the phone call immediately, regardless of this setting.
Use # to End
Dialling
Select Enable if you want to use the pound key (#) to tell the LTE3311 to make the
phone call immediately, instead of waiting the number of seconds you selected in the
Dialling Timeout field.
If you select Enable, dial the phone number, and then press the pound key. The
LTE3311 makes the call immediately, instead of waiting. You can still wait, if you want.
Apply
Click this to save your changes and to apply them to the LTE3311.
Cancel Click this to set every field in this screen to its last-saved value.
To Next Page
Loading...
