Chapter 7 Wireless LAN
LTE3311 Series User’s Guide
73
7.3.4 WPA/WPA2
Select WPA or WPA2 from the Security Mode list.
Note: WPA or WPA2 is not available if you enable WPS before you configure WPA or WPA2
in the Wireless LAN > General screen.
Figure 39 Network > Wireless LAN > General: WPA/WPA2
Pre-Shared Key WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Group Key Update
Timer
The Group Key Update Timer is the rate at which the AP sends a new group key out to
all clients.
The default is 3600 seconds (60 minutes).
Apply Click Apply to save your changes back to the LTE3311.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 22 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK (continued)
LABEL DESCRIPTION
To Next Page
Loading...
