Chapter 7 Wireless LAN
LTE3311 Series User’s Guide
79
7.7 Quality of Service (QoS) Screen
The QoS screen allows you to automatically give a service (such as VoIP and video) a priority level.
Click Network > Wireless LAN > QoS. The following screen appears.
Figure 44 Network > Wireless LAN > QoS
The following table describes the labels in this screen.
7.8 WPS Screen
Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click Network > Wireless LAN > WPS.
Note: With WPS, wireless clients can only connect to the wireless network using the first
SSID on the LTE3311.
Apply Click Apply to save your changes back to the LTE3311.
Cancel Click Cancel to reload the previous configuration for this screen.
Table 27 Network > Wireless LAN > Advanced (continued)
LABEL DESCRIPTION
Table 28 Network > Wireless LAN > QoS
LABEL DESCRIPTION
WMM QoS Select Enable to have the LTE3311 automatically give a service a priority level
according to the ToS value in the IP header of packets it sends. WMM QoS (Wifi
MultiMedia Quality of Service) gives high priority to voice and video, which makes
them run more smoothly.
This field is not configurable and the LTE3311 automatically enables WMM QoS if you
select 802.11n, 802.11gn or 802.11bgn in the Wireless LAN > General screen.
Apply Click Apply to save your changes to the LTE3311.
Cancel Click Cancel to reload the previous configuration for this screen.
To Next Page
Loading...
