Chapter 6 WAN
LTE3311 Series User’s Guide
62
6.6 IPv6
Use this screen to configure the LTE3311’s IPv6 settings. Click Network > WAN > IPv6 from the
Configuration menu.
Figure 32 Network > WAN > IPv6
The following table describes the labels in this screen.
Table 16 Network > WAN > IPv6
LABEL DESCRIPTION
IPv6 Select Enable to allow the LTE3311 to run IPv6. Otherwise, select Disable.
IPv6 Connection Select DHCPv6 if you want to obtain an IPv6 address from a DHCPv6 server.
DNS Setting Select Obtain DNS Server address Automatically to have the LTE3311 get the
IPv6 DNS server addresses from the ISP automatically.
Select Use the following DNS address to have the LTE3311 use the IPv6 DNS
server addresses you configure manually.
Primary DNS Address
Enter the first IPv6 DNS server address assigned by the ISP.
Secondary DNS
Address
Enter the second IPv6 DNS server address assigned by the ISP.
LAN IPv6 Address Enter the IPv6 address for the LTE3311 LAN interface in this field.
LAN IPv6 Link-Local
Address
This shows the IPv6 Link-local address in the LAN side. This is used by LTE3311 when
communicating with neighboring devices on the same link. It allows IPv6-capable
devices to communicate with each other in the LAN side.i
Autoconfiguration Click Enable if you want the devices on your local area network to obtain network
address that are not managed by a DHCPv6 server. Otherwise, select Disable.
Autoconfiguration Type Select Stateless if you want the LTE3311 interface to automatically generate a link-
local address via stateless autoconfiguration.
Select Stateful (DHCPv6) when the devices connected to your LAN needs to have
their TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
To Next Page
Loading...
