Chapter 1 Introduction
LTE3311 Series User’s Guide
17
1.9 Wall Mounting
You may need screw anchors if mounting on a concrete or brick wall.
1 Select a position free of obstructions on a wall strong enough to hold the weight of the device.
2 Mark two holes on the wall at the appropriate distance apart for the screws.
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
3 If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way
in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the
screws all the way in - leave a gap of about 0.5 cm.
WLAN/WPS Green On The LTE3311 is ready and the 2.4GHz wireless LAN is on, but is
not sending/receiving data through the wireless LAN.
Blinking
(slow)
The LTE3311 is sending/receiving data through the wireless
LAN.
Blinking
(fast)
The LTE3311 is negotiating a WPS connection with a wireless
client.
Off The wireless LAN is not ready or has failed or WPS is disabled.
Phone Green On A SIP account is registered for the phone port.
Blinking A telephone connected to the phone port has its receiver off of
the hook or there is an incoming call.
Orange On A SIP account is registered for the phone port and there is a
voice message in the corresponding SIP account.
Blinking A telephone connected to the phone port has its receiver off of
the hook and there is a voice message in the corresponding SIP
account.
Off The phone port does not have a SIP account registered.
USB Green On The LTE3311 has a USB device installed and the 3G connection
is up.
Blinking The LTE3311 is sending/receiving data to/from the USB device
connected to it.
Off There is no USB device installed or the LTE3311 does not detect
a USB connection.
Table 1 Front panel LEDs (continued)
LED COLOR STATUS DESCRIPTION
Table 2 Wall Mounting Information
Distance between holes 11 cm
M4 Screws Two
Screw anchors (optional) Two
To Next Page
Loading...
