Chapter 4 Tutorials
LTE3311 Series User’s Guide
36
3 Click Start buttons (or button next to the PIN field) on both the wireless client utility screen and the
LTE3311’s WPS Station screen within two minutes.
The LTE3311 authenticates the wireless client and sends the proper configuration settings to the
wireless client. This may take up to two minutes. Then the wireless client is able to communicate
with the LTE3311 securely.
The following figure shows you the example to set up wireless network and security on LTE3311
and wireless client (ex. NWD210N in this example) by using PIN method.
Figure 19 Example WPS Process: PIN Method
4.3 Connect to LTE3311 Wireless Network without WPS
This example shows you how to configure wireless security settings with the following parameters
on your LTE3311 and connect your computer to the LTE3311 wireless network.
Follow the steps below to configure the wireless settings on your LTE3311.
WITHIN 2 MINUTES
Wireless Client
Access Point
SSID SSID_Example3
Channel 6
Security WPA2-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
To Next Page
Loading...
