ZyXEL Communications LTE3311 series - What You Need to Know; General Screen

Chapter 21 Bandwidth Management
LTE3311 Series User’s Guide
151
21.3 What You Need To Know
The sum of the bandwidth allotments that apply to the WAN interface (LAN to WAN, WLAN to WAN)
must be less than or equal to the upstream bandwidth that you configure in the Bandwidth
Management > General screen (Section 21.5 on page 152).
The sum of the bandwidth allotments that apply to the LAN interface (WAN to LAN, WAN to WLAN)
must be less than or equal to the downstream bandwidth that you configure in the Bandwidth
Management > General screen (Section 21.5 on page 152).
21.4 General Screen
Use this screen to have the LTE3311 apply bandwidth management.
Click Management > Bandwidth MGMT to open the bandwidth management General screen.
Figure 97 Management > Bandwidth Management > General
The following table describes the labels in this screen.
Table 70 Management > Bandwidth Management > General
LABEL DESCRIPTION
Enable Bandwidth
Management
This field allows you to have LTE3311 apply bandwidth management.
Enable bandwidth management to give traffic that matches a bandwidth rule priority
over traffic that does not match a bandwidth rule.
Enabling bandwidth management also allows you to control the maximum or minimum
amounts of bandwidth that can be used by traffic that matches a bandwidth rule.
Bandwidth of
Upstream
Specify the total amount of bandwidth that you want to dedicate to uplink traffic. The
recommendation is to set this to match the actual upstream data rate.
This is traffic from LAN/WLAN to WAN.
Bandwidth of
Downstream
Specify the total amount of bandwidth that you want to dedicate to downlink traffic. The
recommendation is to set this to match the actual downstream data rate.
This is traffic from WAN to LAN/WLAN.
Flexible Bandwidth
Management
Select Enable to use up to 100% of the configured bandwidth. If you select Disable,
you can only use up to 33% of the configured bandwidth.
Apply Click Apply to save your customized settings.
Cancel Click Cancel to begin configuring this screen afresh.