Chapter 4 Tutorials
LTE3311 Series User’s Guide
35
Note: Your LTE3311 has a WPS button located on its panel, as well as a WPS button in its
configuration utility. Both buttons have exactly the same function; you can use one
or the other.
Note: It doesn’t matter which button is pressed first. You must press the second button
within two minutes of pressing the first one.
The LTE3311 sends the proper configuration settings to the wireless client. This may take up to two
minutes. Then the wireless client is able to communicate with the LTE3311 securely.
The following figure shows you an example to set up wireless network and security by pressing a
button on both LTE3311 and wireless client (the NWD210N in this example).
Figure 18 Example WPS Process: PBC Method
4.2.2 PIN Configuration
When you use the PIN configuration method, you need to use both LTE3311’s configuration
interface and the client’s utilities.
1 Launch your wireless client’s configuration utility. Go to the WPS settings and select the PIN method
to get a PIN number.
2 Enter the PIN number to the PIN field in the Configuration > Network > Wireless LAN > WPS
Station screen on the LTE3311.
Wireless Client
Access Point
SECURITY INFO
COMMUNICATION
WITHIN 2 MINUTES
To Next Page
Loading...
