ZyXEL Communications LTE3311 series - Page 80

Chapter 7 Wireless LAN
LTE3311 Series User’s Guide
80
Figure 45 Network > Wireless LAN > WPS
The following table describes the labels in this screen.
Table 29 Network > Wireless LAN > WPS
LABEL DESCRIPTION
WPS Setup
WPS Select Enable to turn on the WPS feature. Otherwise, select Disable.
PIN Code Select Enable and click Apply to allow the PIN Configuration method. If you select
Disable, you cannot create a new PIN number.
PIN Number This is the WPS PIN (Personal Identification Number) of the LTE3311. Enter this PIN in
the configuration utility of the device you want to connect to the LTE3311 using WPS.
The PIN is not necessary when you use WPS push-button method.
Click Generate to generate a new PIN number.
WPS Status
Status This displays Configured when the LTE3311 has connected to a wireless network using
WPS or when WPS Enable is selected and wireless or wireless security settings have
been changed. The current wireless and wireless security settings also appear in the
screen.
This displays Unconfigured if WPS is disabled and there are no wireless or wireless
security changes on the LTE3311 or you click Release Configuration to remove the
configured wireless and wireless security settings.
Release
Configuration
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the LTE3311.
802.11 Mode This is the 802.11 mode used. Only compliant WLAN devices can associate with the
LTE3311.
SSID This is the name of the wireless network (the LTE3311’s first SSID).
Security This is the type of wireless security employed by the network.
Apply Click Apply to save your changes back to the LTE3311.
Cancel Click Cancel to reload the previous configuration for this screen.