Chapter 24 Maintenance
LTE3311 Series User’s Guide
168
Click Maintenance > Backup/Restore. Information related to factory defaults, backup
configuration, and restoring configuration appears as shown next.
Figure 117 Maintenance > Backup/Restore
The following table describes the labels in this screen.
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default LTE3311
IP address (192.168.1.1). See Appendix C on page 190 for details on how to set up
your computer’s IP address.
Table 80 Maintenance > Backup/Restore
LABEL DESCRIPTION
Backup Click Backup to save the LTE3311’s current configuration to your computer.
File Path Type in the location of the file you want to upload in this field or click Browse... to find it.
Browse... Click Browse... to find the file you want to upload. Remember that you must decompress
compressed (.ZIP) files before you can upload them.
Upload Click Upload to begin the upload process.
Note: Do not turn off the LTE3311 while configuration file upload is in progress.
After you see a “configuration upload successful” screen, you must then wait one minute
before logging into the LTE3311 again. The LTE3311 automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Reset Pressing the Reset button in this section clears all user-entered configuration information
and returns the LTE3311 to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
LTE3311. Refer to the chapter about introducing the Web Configurator for more information
on the RESET button.
To Next Page
Loading...
