Chapter 7 Wireless LAN
LTE3311 Series User’s Guide
68
Note: If you are configuring the LTE3311 from a computer connected to the wireless LAN
and you change the LTE3311’s SSID, channel or security settings, you will lose your
wireless connection when you press Apply to confirm. You must then change the
wireless settings of your computer to match the LTE3311’s new settings.
Click Network > Wireless LAN to open the General screen.
Figure 35 Network > Wireless LAN > General
The following table describes the general wireless LAN labels in this screen.
Table 19 Network > Wireless LAN > General
LABEL DESCRIPTION
Wireless LAN
Status
Select Enable to activate the 2.4GHz wireless LAN. Select Disable to turn it off.
You can also enable or disablethe 2.4GHz wireless LANs by using the WIFI button located
on the back panel of the LTE3311.
Name (SSID) The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Channel Selection Set the operating frequency/channel depending on your particular region.
Select a channel from the drop-down list box. The options vary depending on the
frequency band and the country you are in.
Refer to the Connection Wizard chapter for more information on channels. This option is
only available if Auto Channel Selection is disabled.
Auto Channel
Selection
Select this check box for the LTE3311 to automatically choose the channel with the least
interference. Deselect this check box if you wish to manually select the channel using the
Channel Selection field.
Operating
Channel
This displays the channel the LTE3311 is currently using.
To Next Page
Loading...
