Chapter 7 Wireless LAN
LTE3311 Series User’s Guide
71
Figure 37 Network > Wireless LAN > General: Static WEP
The following table describes the wireless LAN security labels in this screen.
Table 21 Network > Wireless LAN > General: Static WEP
LABEL DESCRIPTION
Security Mode Select Static WEP to enable data encryption.
WEP Encryption Select 64-bits or 128-bits.
This dictates the length of the security key that the network is going to use.
Authentication
Method
Select Auto or Shared Key from the drop-down list box.
This field specifies whether the wireless clients have to provide the WEP key to log into
the wireless network. Keep this setting at Auto unless you want to force a key
verification before communication between the wireless client and the LTE3311 occurs.
Select Shared Key to force the clients to provide the WEP key prior to communication.
ASCII Select this option in order to enter ASCII characters as WEP key.
Hex Select this option in order to enter hexadecimal characters as a WEP key.
The preceding "0x", that identifies a hexadecimal key, is entered automatically.
To Next Page
Loading...
