Chapter 7 Wireless LAN
LTE3311 Series User’s Guide
83
Figure 48 Network > Wireless LAN > WDS
The following table describes the labels in this screen.
Table 32 Network > Wireless LAN > WDS
LABEL DESCRIPTION
WDS Setup
Basic Setting Select Disable to turn off the WDS function on the LTE3311.
Select AP+Bridge to have the LTE3311 function as a bridge and access point
simultaneously.
Select Bridge Only to have the LTE3311 act as a wireless bridge only.
Local MAC Address This shows the MAC address of the LTE3311.
Phy Mode Select the physical mode supported by the LTE3311.
You must also set the peer device to use the same physical mode.
Remote MAC
Address
Type the MAC address of the peer device in a valid MAC address format, that is, six
hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Security
Encryp Type Select the type of security you want to use (TKIP or AES) to secure traffic on your
WDS. Otherwise, select No Security.
Select TKIP to enable Temporal Key Integrity Protocol (TKIP) security on your WDS.
This option is compatible with other ZyXEL access points that support WDS security. Use
this if the other access points on your network support WDS security but do not have an
AES option.
AES provides superior security to TKIP. Use AES if the other access points on your
network support it for the WDS.
Encryp Key Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including spaces
and symbols).
You must also set the peer device to use the same pre-shared key.
Apply Click Apply to save your changes back to the LTE3311.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
