Chapter 8 Storage Manager
Cloud Storage User’s Guide
93
Map iSCSI LUNs
If the existing iSCSI target doesn’t map to any iSCSI LUN, go to Map iSCSI LUNs to configure the
mapping.
Figure 54 iSCSI Targets > Edit > Map iSCSI LUNs
CHAP Username - The user name is for the initiator to authenticate the initiator when
attempting connection.
Password - The password is for the target to authenticate the initiator when attempting
connection.
Confirm password - Re-type the password to make sure you entered it correctly.
Note: Valid characters for password are 0-9, a-z, and A-Z, and the valid length is 12-14
characters.
Enable mutual
CHAP
Select this check box to perform mutual CHAP on the target.
Username - The user name is for the target to authenticate the initiator when
attempting connection.
Password - The password is for the target to authenticate the initiator when attempting
connection.
Confirm password - Re-type the password to make sure you entered it correctly.
Note: Valid characters for password are 0-9, a-z, and A-Z, and the valid length is 12-14
characters.
Apply Click Apply to save your changes.
Cancel Click Cancel to close the screen without saving any settings.
Table 26 iSCSI Targets > Edit > Properties (continued)
LABEL DESCRIPTION
To Next Page
Loading...
