To Next Page

To Previous Page

Mounting - Completion

2.4

WRONG

Gap between plastic cover and

loudspeaker seal

- water may leak in and

damage electronics

If the loudspeaker support is in a

wrong position, the plastic cover

may catch the support brim (see

the arrow) and, if treated roughly,

lead to component deformations.

Leakage may arise, see the upper

arrow.

Properly tightened screw

RIGHT

The seal touches the plastic

cover. Water flows out through a

small hole (not shown in the

figure).

Note: Water does not affect the

loudspeaker Mylar membrane.

Other manuals for 2N Helios IP

Questions and Answers:

Need help?

Do you have a question about the 2N Helios IP and is the answer not in the manual?

General

Type	IP Intercom
Connectivity	Ethernet
Tamper Switch	Yes
Audio	Full duplex
Microphone	Built-in
Speaker	Built-in
Camera	Yes
Power Supply	PoE
Operating Temperature	+60°C
Ingress Protection	IP54
Protocols	SIP, RTSP, ONVIF
Audio Codec	G.711, G.722
Installation	Surface mount, flush mount (depending on model)