Acoustic Signalling and Keypad Configuration
42
3.1 Acoustic Signalling and Keypad
Configuration
2N
®
Helios IP generates sounds to signal operational mode switching and changes.
There are different types of acoustic signals for each type of status change. The list of
signals is included in Table 3.1.
Tone Signalling
User activated
after entering the user activation code. The activation code is
used for activating a user (a telephone directory position). For
activation code setting refer to the Telephone Directory
subsection
User deactivated
after entering the user deactivation code. The deactivation code is
used for deactivating a user (a telephone directory position). A
deactivated user may not be called but the call may, if necessary,
be forwarded to a substitute if defined. For deactivation code
setting refer to the Telephone Directory subsection.
Scheduler activated
used for scheduler activation. It can be used, for example, to
enable alerting of a user group of users in an office. For activation
code setting refer to the Scheduler subsection.
Scheduler deactivated
used for scheduler deactivation. It can be used, for example, to
disable alerting a user group in an office and forward the call to a
selected telephone number, or the reception or a cellular phone.
For deactivation code setting refer to the Scheduler subsection.
Call prolongation confirmation signalling
a maximum call duration is set for blocking protection reasons,
see the Miscellaneous subsection.
Internal application launched
after turning on or restarting of 2N
®
Helios IP, the internal
application of 2N
®
Helios IP is launched. A successful launch is
signalled by this tone combination.
Connected to LAN, IP address received
after the launch of the internal application 2N
®
Helios IP logs into
the LAN. A successful login is signalled by this tone combination.
To Next Page
Loading...
Need help?
General
