2N Helios IP User Manual

Configuration
3.3
64
Locks
This menu helps you set the opening codes and modes for locks 1 to 4 attached to
2N
®
Helios IP (for Part Nos. 9137131(CK)E, 9137161(CK)E and 9137111(CK), locks 3
and 4 are supported only if a licence key is inserted, Part No. 9137901).
Figure 3.17 Lock Settings
Lock Settings
Lock enabled
Enable or disable lock control globally. If disabled, the lock cannot be opened with
any of the codes entered (including the user lock codes) or activated by a call or
speed dialling button.
Time profile
Assign a time schedule to the lock code for global management. If the assigned
time schedule is not active, the lock switch cannot be opened with a lock code or
activated by a call or speed dialling button. Refer to the Scheduler subsection for
details on time schedule settings.

2N Helios IP Specifications

General

Type	IP Intercom
Connectivity	Ethernet
Tamper Switch	Yes
Audio	Full duplex
Microphone	Built-in
Speaker	Built-in
Camera	Yes
Power Supply	PoE
Operating Temperature	+60°C
Ingress Protection	IP54
Protocols	SIP, RTSP, ONVIF
Audio Codec	G.711, G.722
Installation	Surface mount, flush mount (depending on model)