94
Caution
This selection does not apply to the network settings to avoid network
collision and disabling the option to configure using the administration web
server. To reset the network settings to default values use the procedure
described in the Switching to Default Network Parameters – Static IP
Address and Switching to Default Network Parameters – Dynamic IP
Address subsections.
Display Program
This menu is used for display program uploading. The display program is prepared
using the configuration tool available on the attached CD. For display settings refer to
the Display subsection.
Display Program Uploading
Used for uploading the display program to 2N
®
Helios IP. Use the Browse button
to select the configuration file and push to upload it to 2N
®
Helios IP. If no
file is selected, the current display program is removed from the memory when
this button is pressed.
Figure 3.41 Display Program Uploading
To Next Page
Loading...
