2N Helios IP User Manual

Configuration
3.3
88
System Log
This menu is used for configuration of system and log message sending. This service is
useful for solving 2N
®
Helios IP errors if any and contacting the 2N TELEKOMUNIKACE
a.s. Technical Support. Normally, it is not necessary to configure this menu. To receive
syslog messages, a syslog server has to be installed in your PC.
Figure 3.37 System Log
Logging enable
Enable or disable sending of system and log reports and storing them on the
syslog server.
Trace level
Set the level of detail of the reports.
Syslog server
The IP address of the server on which the system log application is running.
Miscellaneous
Here set the additional parameters of 2N
®
Helios IP that were not included in the
above-described menus.

2N Helios IP Specifications

General

Type	IP Intercom
Connectivity	Ethernet
Tamper Switch	Yes
Audio	Full duplex
Microphone	Built-in
Speaker	Built-in
Camera	Yes
Power Supply	PoE
Operating Temperature	+60°C
Ingress Protection	IP54
Protocols	SIP, RTSP, ONVIF
Audio Codec	G.711, G.722
Installation	Surface mount, flush mount (depending on model)