2N Helios IP User Manual

Configuration
3.3
90
Incoming Calls
Automatic answer
Defines how 2N
®
Helios IP should behave when a call is coming. If the Automatic
answer is disabled, 2N
®
Helios IP signals an incoming calls by ringing and the
external subscriber can answer or reject the call by pushing * or # respectively. If
the Automatic answer is enabled, 2N
®
Helios IP receives the call automatically and
processes as selected in the Activation mode and Activation code parameters.
Activation mode
If the Automatic answer is enabled, incoming calls are received automatically by
2N
®
Helios IP. 2N
®
Helios IP enables you to receive up to 3 incoming calls at the
same time. You can control 2N
®
Helios IP through incoming calls using tone
dialling from your telephone keypad (activate or deactivate users or profiles,
e.g.). A single incoming call may only be connected with the 2N
®
Helios IP
microphone, loudspeaker and camera. Use the Activation mode parameter to
define whether the incoming call should be connected automatically, or the
activation code should be required for connection (see below).
Activation code
Set the activation code necessary for interconnecting the incoming call audio and
video if the Automatic answer is enabled and the Activation code is set to Manual.
Beep on connect
Use this parameter to enable/disable 2N
®
Helios IP connection signalling by a beep
during an incoming call.
Keyboard Settings
Hang up by # button
Enable call termination with the # key.
Same button function
Assign a function to the call-establishing quick dialling button when re-pushed.
None – re-pushing the quick dialling button does not affect the set up or
active call.
Hang-up – re-pushing the quick dialling button ends the set-up or active call.
Dial next – re-pushing the quick dialling button allows you to skip an attempt
to set up a call and proceed to the next telephone
number in the directory for another set-up.
Flash – re-pushing the quick dialling button sends the FLASH signal into the
active call.
Quick dialling using digits
Enable user calling from the telephone directory by dialling the user number (two
or three digits) and confirmation with *.
Floor & Apartment dialling
Enable special calling to numbers included in the telephone directory by entering a
floor number on the numerical keypad and pushing a quick dialling button.
Buttons 1 – 6 represent apartments on the floor (A through F). The following

2N Helios IP Specifications

General

Type	IP Intercom
Connectivity	Ethernet
Tamper Switch	Yes
Audio	Full duplex
Microphone	Built-in
Speaker	Built-in
Camera	Yes
Power Supply	PoE
Operating Temperature	+60°C
Ingress Protection	IP54
Protocols	SIP, RTSP, ONVIF
Audio Codec	G.711, G.722
Installation	Surface mount, flush mount (depending on model)