2N Helios IP User Manual

Configuration
3.3
89
Figure 3.38 Miscellaneous Settings
Outgoing Calls
Ring time limit
Set the call set-up and ringing time limits for outgoing calls. If the calls are routed
through the GSM gateways of Part Nos. 505004, 505214 or 505612 to the GSM
network, it is advisable to set a time value longer than 20 s.
Call time limit
Set the maximum call duration. When the call end is approaching, 2N
®
Helios IP
starts generating tones signalling the end of the call. The call will automatically be
terminated 10s after this signal. To prolong the call, send a DTMF code (push #,
e.g.) on your phone.
Dial cycles limit
Set the maximum count of telephone directory searching attempts. The function is
useful whenever the substitute is defined and in the case of deadlock.

2N Helios IP Specifications

General

Type	IP Intercom
Connectivity	Ethernet
Tamper Switch	Yes
Audio	Full duplex
Microphone	Built-in
Speaker	Built-in
Camera	Yes
Power Supply	PoE
Operating Temperature	+60°C
Ingress Protection	IP54
Protocols	SIP, RTSP, ONVIF
Audio Codec	G.711, G.722
Installation	Surface mount, flush mount (depending on model)