2N Helios IP - Surface Mounting

Mounting – Mechanical Installation
2.2
22
Indoor application means:
Indoor areas with a low relative air humidity value (e.g., hallways,
offices and other heated rooms).
Indoor areas where humidity condenses on walls but never flows
down the walls (porches, storage areas, industrial areas, e.g.).
Outdoor areas where protection against rain and water flowing
down the wall is provided (sheds, passages. e.g.).
Outdoor application means:
Environments where the product is exposed to rain or where water
may flow down the walls (fence, outer wall of a building, e.g.).
Caution
 The warranty shall not apply to product failures and defects caused by
improper installation (contrary to these instructions). The manufacturer is
neither liable for damages caused by theft within an area that is accessible
after the attached electric lock is switched. The product is not designed as
a burglar protection device except when used in combination with a
standard lock, which has the security function.
Surface Mounting
Figure 2.1 Hole Drilling
1. Drill holes according to the template included in the 2N
®
Helios IP supply.
Insert the included dowels in the wall holes.
2. Use the hexagonal wrench included in the supply and remove the 2N
®
Helios
IP metal cover. Remove the screw in the lower part of the metal cover and
fold out the cover as shown in Figure 2.2.
3. Use a cross-head screwdriver to remove the plastic cover and demount the
cover.