To Next Page

To Previous Page

Acoustic Signalling and Keypad Configuration

3.1

Figure 3.2 Switching to Default Network Parameters – Static IP Address (Part Nos. 9137160E,

9137160CE, 9137160CKE, 9137161E, 9137161CE, 9137161CKE)

Figure 3.3 Switching to Default Network Parameters – Static IP Address (Part Nos. 9137110E,

9137110CE, 9137110CKE, 9137111E, 9137111CE, 9137111CKE)

For one-button 2N

Helios IP modules (Part Nos. 9137110E, 9137110CE,

9137110CKE, 9137111E, 9137111CE, 9137111CKE), pushing key 1 fifteen times

within 30 seconds after the internal application launch results in turning on of the

web server and switching the network parameters from the DHCP to the default static

IP address and vice versa.

Other manuals for 2N Helios IP

Questions and Answers:

Need help?

Do you have a question about the 2N Helios IP and is the answer not in the manual?

General

Type	IP Intercom
Connectivity	Ethernet
Tamper Switch	Yes
Audio	Full duplex
Microphone	Built-in
Speaker	Built-in
Camera	Yes
Power Supply	PoE
Operating Temperature	+60°C
Ingress Protection	IP54
Protocols	SIP, RTSP, ONVIF
Audio Codec	G.711, G.722
Installation	Surface mount, flush mount (depending on model)