3D Systems CubePro - Page 55

513D Systems, Inc.
NOTE: The build le may take a few minutes to create. During this
time, the le is being converted from a .stl le to a .cubepro le.
NOTE: Once the build is complete, the estimated print time will
appear. Select OK to close the window.
NOTE: Once the le has been built, it must be sent to the printer. There are two ways to send the le:
• Wireless
• USB Mass Storage Device
NOTE: Larger les will take longer to send to the printer using a wireless connection. Transferring larger les with
a USB mass storage device is strongly recommended.
11. To save to a USB mass storage device, select Save. Browse to the connected
mass storage device and select Save. If sending wirelessly, go to step 13.
NOTE: The le must be stored in the root directory of the USB mass
storage device.
12. Insert the USB mass storage device into the printer’s USB inlet port. Proceed to
step 14.
13. To send the le to the printer using the wireless utility, select Send.
14. Select PRINT on the printer touchscreen display.
NOTE: Refer to the section titled Printing Your Creation for more
information.