Operational Features
5-37 41-001343-02 REV05 – 07.2014
Configuring Wideband Audio Equalizer Settings Using the IP Phone UI
Use the following procedure to configure the wideband audio equalizer settings using the IP phone’s UI.
Configuring Wideband Audio Equalizer Settings Using the Configuration Files
Use the following parameters to configure the wideband audio equalizer settings using the configuration files.
IP Phone UI
1.
Press on the phone to enter the Options List.
2. Press the <Audio> button.
3. Navigate to the second page and press the <WBand RX Filters> key.
4. Press the settings button next to the audio path (i.e. Speaker or Handset) you would like to make changes to.
5. Press the wideband audio equalizer setting you want to apply for the audio path. The default settings for the respective audio paths are Spkr
Setting1 and HS Setting1.
6.
Press the to return to the previous menu or press the to return to the idle screen.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Wideband Audio Equalizer Settings” on pageA-57.
To Next Page
Loading...
