Aastra 6730I - Alphanumeric Input Order for Username Prompts

Advanced Operational Parameters
A-222 41-001343-02 REV05 – 07.2014
RTCP Summary Reports
Alphanumeric Input Order for Username Prompts
Parameter –
sip rtcp summary reports transport protocol
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Specifies the transport protocol used for sending RTCP summary reports. This
parameter takes effect when at least one line has RTCP summary reports enabled.
Note:
The parameter "sip symmetric udp signaling" is effective when the transport protocol for
RTCP summary reports is set to UDP.
Format Numeric
Default Value 1 (UDP)
Range 0 (TCP/UDP)
1 (UDP)
2 (TCP)
Example sip rtcp summary reports transport protocol: 2
Parameter –
username alphanumeric input order
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description When enabled, this parameter changes the default behavior of the keypad input order
during username prompts from uppercase letters > digit > lowercase letters to digit >
uppercase letters > lowercase letters.
For example, when pressing “2” on the keypad during a username prompt with this
parameter disabled (default) each key press will successively enter the letter/digit A, B,
C, 2, a, b, c. When enabled, each key press will successively enter 2, A, B, C, a, b, c.
Format Integer
Default Value 0 (Uppercase letters first
Range 0-1
0 (Uppercase letters first)
1 (Digit first)
Example username alphanumeric input order: 1