Operational Features
41-001343-02 REV05 – 07.2014 5-64
XML Beep Support
The IP phones have a feature that allows you to enable or disable a beep on the phone when it receives a status message
from an XML application. This beep can be turned ON or OFF using the Aastra Web UI, the configuration files, or in an XML
script. If you disable this feature, then no beep is heard when the XML application arrives to the phone.
If your System Administrator has set a value for this feature in a custom XML application or in the configuration files, the
value you set in the Aastra Web UI overrides the Administrator’s setting. Setting and saving the value in the Aastra Web UI
applies to the phone immediately.
Reference
For more information about enabling/disabling the XML Beep Support in an XML script, see “XML Customized Services”
on page5-246.
Configuring XML Beep Support
Use the following procedures to enable/disable XML Beep Support.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “XML Settings” on pageA-114.
Aastra Web UI
1. Click on Basic Settings->Preferences->General.
2. The “XML Beep Support” field is enabled by default. To disable this field, uncheck the box.
3. Click Save Settings to save your changes.
To Next Page
Loading...
