Aastra 6730I - No Service Congestion Tone

Operational Features
41-001343-02 REV05 – 07.2014 5-94
phone receives a call for any line other than the line that is being used to dial out. When the phone exits the ringing state
(e.g. the incoming call is answered), the tone device of the phone will revert back to originally configured audio device.
Feature compatibility is dependant on the IP phone model (see the following table for compability details).
Configuring the Ring Tone via Speaker During Active Calls Feature
Use the following procedures to configure the ring tone via speaker during active calls feature.
No Service Congestion Tone
Administrators can configure the IP phones to play a congestion/fast busy tone instead of a dial tone when the phone is in
a “No Service” state. This feature allows visually impaired persons the ability to discern whether or not the phone is in serv-
ice and can be used to send/receive calls.
The configuration parameter “no service congestion tone” allows administrators the ability to enable this accessibility
feature. When enabled, the congestion tone will replace the conventional dial tone when the handset is off hook, a head-
set is employed, or the speakerphone is engaged. The congestion tone’s frequency/pattern is based on the respective
phone’s configured tone set. Additionally, the congestion tone is played on a per-line basis whereby only the specific lines
that are without service are affected.
IP Phone Handset Audio Mode Speaker Audio Mode
9143i
XX
9480i and 9480i CT

X
6730i
XX
6731i
XX
6735i

6737i

6739i

X
6753i

X
6755i

X
6757i and 6757i CT

X
6863i

6865i

6867i

Notes:
• The “ring audibly enable” parameter is disabled by default.
• This feature is not supported when utilizing the headset audio mode.
• With this feature enabled and when the phone’s speaker is playing the incoming call’s ring tone, call-waiting tones
will not be played.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Ring Tone via Speaker During Active Calls Settings” on
pageA-122.
Note:
If the phone or individual lines are configured to have no registration by intent (e.g. if the Registrar is set to 0.0.0.0) ena-
bling the “no service congestion tone” parameter will have no effect and the default dial tone will be played.