Operational Features
41-001343-02 REV05 – 07.2014 5-74
Customizable Message Waiting Indicator (MWI) Request URI
In Release 3.1 and up, an Administrator can enter a parameter in the configuration files to customize the request-URI for
MWI feature subscription. This parameter is called “sip linex mwi request uri”.
This feature can be set on a per-line basis using the configuration files only.
Configuring Message Waiting Indicator (MWI) Request URI
Use the following procedure to configure an MWI request URI on the IP phone.
Aastra Web UI
1. Click on Basic Settings-> Preferences->General.
2. In the “Message Waiting Indicator Line” field, select a single line from 1 to 9, or select “All” for all lines. If you select a single line, the MWI
illuminates when a voicemail message is pending on that line. If you select all lines, the MWI illuminates when a voicemail message is pend-
ing on any line from 1 to 9.
3. Click Save Settings to save your changes.
Note:
“Sip Explicit MWI Subscription” must be enabled to use this feature. For more information about the Sip Explicit MWI
Subscription” parameter, see “Advanced SIP Settings (optional)” on page4-69.
Configuration Files
For the specific parameter you can set in the configuration files, see Appendix A, the section, “Message Waiting Indicator Settings” on pageA-127.
To Next Page
Loading...
