Aastra 6730I - Page 321

Operational Features
41-001343-02 REV05 – 07.2014 5-80
Configuring LLDP-MED and ELIN
Use the following procedures to configure LLDP-MED and ELIN on the IP phones.
Use the following procedure to enable/disable LLDP-MED using the IP Phone UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “LLDP-MED and ELIN Settings” on pageA-112.
Note:
You cannot configure the “LLDP Interval” or the “Use LLDP ELIN” parameters via the IP Phone UI.
IP Phone UI
1. Press Options, and then select Administrator Menu.
2. Select Network Settings.
3. Select Ethernet & VLAN.
4. Select LLDP Support.
5. Press CHANGE to toggle the LLDP setting to Enabled or Disabled.
This field enables or disables Link Layer Discovery Protocol for Media Endpoint Devices (LLDP-MED) on the IP Phone.
6. Press DONE to save the change.
For the 6739i:
1.
Press on the phone to enter the Options List.
2. Press the <Advanced> and enter your Administrator password using the pop-up keyboard.
3. Press the <Network> button, navigate to the second page and press <Ethernet & VLAN>.
4. Navigate to the second page and press the button beside <LLDP Support>.
This option enables or disables Link Layer Discovery Protocol for Media Endpoint Devices (LLDP-MED) on the IP Phone.
5. Press the <Enable> button the enable the feature.
6.
Press the to return to the previous menu or press the to return to the idle screen.
For the 6867i:
1.
Press to enter the Options List.
2. Press the Advanced softkey.
3. Enter the Administrator password using the keypad. Default is “22222”.
4. Select Network > LLDP.
This option enables or disables Link Layer Discovery Protocol for Media Endpoint Devices (LLDP-MED) on the IP Phone.
5.
Use the
5 and 2 keys enable or disable the feature.
6. Press the Save softkey.